Wheels MFG Headtube Drift

Headtube drifts for use with the Wheels MFG Headset Cup Press. 1/2" thru hole. Drift is machined with multiple steps to fit common head tube inner diameters listed below. Not recommended for use with Wheels Mfg PRESS-1 or PRESS-4 handles and rod, which have a smaller 3/8" diameter rod.

• Machined aluminum
• Red anodized
• 1/2" hole for use with Wheels MFG Headset Cup Press (PRESS-8) only. Not for use with our PRESS-1 or PRESS-4 handles.
• Headtube drift fits the following Inner Diameters:
- 34mm
- 44mm
- 49mm
- 56mm

**Wheels MFG does not recommend it for use with PRESS-1 or PRESS-4 handles, or any other press with a rod diameter less than 1/2". When used with a smaller rod, it is almost impossible to prevent the cups from pressing in straight.